1. Forum
  2. Usenet
  3. REC.CRAFTS.METALWORKING

  • Re: Tyzack lathe

    From Mike East@21:1/5 to All on Fri Nov 4 19:01:26 2022
    I know it is a long time ago to reply. In answer to your question, I have a hobson H7 lathe and I have compared the tables to the zyto lathe gear set and they tally. The zyto is is a machine which I am rebuilding. I can email the tables if you wish. The
    ratio between the quill and the first driver after the tumbler are the same. Te zyto gears are the same DP as the hobson 20dp Regards Mike East

    --
    For full context, visit https://www.polytechforum.com/metalworking/tyzack-lathe-649882-.htm

    --- SoupGate-Win32 v1.05
    * Origin: fsxNet Usenet Gateway (21:1/5)
  • From Lathe noobie@21:1/5 to All on Sun Apr 23 16:32:21 2023
    Hi tyzack hope you and yours are well.
    I know your post was a long time ago but I have just seen it while searching for information on the Hobson H7 lathe and how to use it as I have no experience with lathes.
    I thought it would possibly to turn a 180mm shaft to size how wrong can you be!!
    So hopefully you are willing to impart some much needed knowledge and wisdom

    --
    For full context, visit https://www.polytechforum.com/metalworking/tyzack-lathe-649882-.htm

    --- SoupGate-Win32 v1.05
    * Origin: fsxNet Usenet Gateway (21:1/5)